Ultrasonic Testing: Training & Certification

Ultrasonic principles; properties of sound; waves, frequencies, sound beam, attenuation; gauges for measuring thicknesses and flaw, ultrasonic compression probes; calibration blocks, methods of calibration, sensitivity and sizing techniques, testing of plates, lamination and thickness, etc.

Ultrasonic Testing:

Contents:
Training & Certification, The following are some of the training contents with regards to Ultrasonic Testing:

- Principles of Ultrasonic Testing
- Generation of Ultrasonic Testing
- Properties of the transducer or probes
- Acoustic impedance, Beam Divergence – Dead, Near and Far Zone
- Influence of properties of test object on sound propagation
- Sound velocity and attenuation
- Equipment – controls and functions of ultrasonic instrument
- Signal presentation – A,B,C and D scans
- Scanning techniques – manual, semi-automatic, automatic
- Immersion testing and Through-transmission technique – basic principle
- Calibration of Testing Systems
- Sensitivity setting – simple methods, BWE, DAC
- Detectability of Defects – advantages and limitations of the test method with regard to defect detection
- Factors Affecting the Performance of the Ultrasonic Test
- Conducting and Recording the Test
- Procedure to be adopted to carry out the test and Flaw assessment, sizing techniques and reporting
- Snell’s Law concerning reflection, Refraction, mode conversion and Calculations
- Interpretation of test Results to acceptance standards
- Basic Welding Process and product technologies
- Types of defect associated with particular parent metal/welding process combinations
- Examination of parent plate, butt welds and configuration joints

Objectives:
At the end of the course, attendees shall be able to:

- Select suitable NDT technique and test method to be used
- Define the limitations of application of the testing method
- Translate NDT standards and specifications into NDT
- Measure thickness of steel plates & determine levels of attenuation
- Conduct test as per specifications
- Interpret and evaluate results according to applicable standards
- Organise and report the results of non-destructive tests
- Meets syllabus requirements for PCN or ISO9712 examinations

Time Table Of Course :

Day 1 to Day 5
- Introduction of NDT
- Theory - General,Specific and Product Technology
- Course work

Day 6 - Day 15
- Understanding about Instrument
- Calibration
- Construct Beam Profile
- Construct D.A.C
- Plotting System
- Scanning Technique
- Scanning (Lamination,Plate,Pipe,Nozzle and Node)
- Detection any Inclusion or Lamination
- Reporting

Upcoming Course Listing

  • Course Start : 08 Jan 2018
    Course End : 26 Jan 2018 Sign Up Now

Course Schedule

November 2017
SunMonTueWedThuFriSat
2930311234
567891011
12131415161718
19202122232425
262728293012
3456789
December 2017
SunMonTueWedThuFriSat
262728293012
3456789
10111213141516
17181920212223
24252627282930
31123456
January 2018
SunMonTueWedThuFriSat
31123456
78910111213
14151617181920
21222324252627
28293031123
45678910